The Wonderland Board

I've made a model of a cannon (I'm still trying to record a good video) but the problem is when I use jafo's editor tools, I copy the line, and change everything, but nothing works, it tells found the conversion data but can't be converted, I saw the wop, it's was like this.
and the wop data is like this :1:Custom\cannon\cannon.3ds

In Conversion data add this line:
:1:|Custom\cannon\cannon.3ds|!None|!None|0.0|0.0|0.0|0.0|0.0|0.0|0.0

Then go to your custom folder and rename your cannon model to dboopo.wd3 or save it as dboopo.wd3

The wop looks good.
Try it!

it's saying, length cannot be less than zero.

it's saying, length cannot be less than zero.

Sorry, been too busy to check the forum lately. Send me your WOP and "ConverterData.txt" files and I'll take a look at them.

EDIT:
It appears to me that, in your WOP, the length for :1:Custom\cannon\cannon.3ds may not be set correctly since your screen shot shows :1:Custom\cannon\cannon.3 for the conversion flag. Make sure the 4 bytes before the flag is 1B 00 00 00.

Also the CoverterData.txt line Antonio gave you is missing an element. It should be:

:1:|Custom\cannon\cannon.3ds|!Square|!None|!None|0.0|0.0|0.0|0.0|0.0|0.0|0.0

jafo1015 wrote:Sorry, been too busy to check the forum lately. Send me your WOP and "ConverterData.txt" files and I'll take a look at them.

EDIT:
It appears to me that, in your WOP, the length for :1:Custom\cannon\cannon.3ds may not be set correctly since your screen shot shows :1:Custom\cannon\cannon.3 for the conversion flag. Make sure the 4 bytes before the flag is 1B 00 00 00.

Also the CoverterData.txt line Antonio gave you is missing an element. It should be:

:1:|Custom\cannon\cannon.3ds|!Square|!None|!None|0.0|0.0|0.0|0.0|0.0|0.0|0.0

BIG BUMP

I didn't read because I wasn't In the forums that day.
I've inserted an 1B but now the :1:custom\cannon\cannon.3ds has disappeared...will it still work?